No results were found for the filter!
NEW
Cooling spiral for installation in 30 hl... Cooling spiral for installation in fermenting vats with a diameter of approx. 1550 mm. The spiral is made of stainless steel V4A. Diameter spiral: 1150 mm Cooling surface approx. 0,5 sqm for 30 hl Operating pressure maximum 6 bar
NEW
Mash sieve made of stainless steel Mash sieve made of stainless steel V4A, consisting of the sieve and the frame for removal. The mash strainer is installed inside the fermenter, above the residual or clear drain. Dimensions: (L x W x H) 600 x 400 x 330 mm Stainless steel...
Dome lid 220 mm - stainless steel Round dome lid stainless steel V4A specially shaped for oval and round wooden barrels. The dome lid is attached instead of the bunghole to enable e.g. easier filling and emptying of a rotary fermenter. Diameter approx. 220 mm AISI 316...
Acrylic tube for filling level valve for large... Made of stainless steel - for screwing into large casks With plexiglass level indicator
Fill level indicator valve Made of stainless steel - for screwing into large casks With plexiglass level indicator
Wooden bung with sulphur wire Conical wooden bung with stainless steel eyelet in a set with a stainless steel wire bent at the ends, which allows the sulphur cuts to be hung in the barrel. Dimensions bung ca.: Length: 100 mm Ø: 40 - 60 mm Dimensions stainless steel...
Wooden bung with desulphurization basket Conical wooden bung with stainless steel eyelet in a set with a stainless steel basket attached to the rope, which allows the hanging of several sulphur cuts in the barrel. Dimensions ca.: Bung: Length: 100 mm Ø: 40 - 60 mm Length rope :...
Dome lid 600 mm - stainless steel Round dome lid made of V4A stainless steel for installation in vats. Dimensions ca.: Ø 600 mm
Bung hole ring - stainless steel Bung hole ring - stainless steel for screwing into the bunghole. Made of high-quality stainless steel from V4A, to be screwed into the bunghole of the barrel. The barrel can then be closed pressure-safe by the corresponding counter...
Sealing set for wine lifter Replacement seals for the compressed air wine lifter One set contains: Amount Spare part number 1 1-5 1 1-8 1 1-9 1 1-13 1 2-2 3 2-3 1 3-1 1 4-1 1 5-2 The position of the seal can be found in the PDF provided.
Stainless steel bunghole bush Stainless steel bunghole bush for screwing into the bunghole, ensures absolute hygiene when filling in and out and impresses with its high-quality appearance. Dimensions ca.: Depth 35 mm Ø 60 mm at the outer point of the Thread runs...
Calotte foot Calotte foot made of polished stainless steel V2A, the professional shelter for your barrel storage. The square plate is firmly screwed to the underside of the drum bearing. The threaded bolt is firmly fixed on the upper side in the nut...