No results were found for the filter!
The beer barrels are made of dried Oak wood and the end of the staves are red painted. The outside of the barrel has been left pure, whereas the inside has been treated with pitch. Dimensions approx.: Volume 20 l 50 l Length cm 42 57...
A freshly tapped one, always a pleasure! Beer barrel table made of solid, oiled light wood for beer barrels with Bavarian tap. The beer barrel has a safe stand on the table. Due to the slight inclination it can run empty without any...
Tap and air valve made of brass with cylinder seal for beer barrels with siphon box. Dimensions Tap approx.: Length: 20 cm High: 10 cm Ø Composition: 2.5 cm Dimensions Valve approx.: Length: 10 cm Ø Max.: 3 cm Ø Composition: 2.5 cm
The plastics corks are for closing the siphon box, where later the tap and the valve are driven. Dimension approx.: ø: 2 cm Length: 2 cm 1 Pack includes 10 pieces.
The bung screw is for the larger howl, threaded in the middle of the belly of the barrel. The bung screw is made of stainless steel and is suitable for 43mm bung rings. Dimension approx.: ø Max.: 4,5 cm Length: 4 cm
The bung screw is for the larger howl, threaded in the middle of the belly of the barrel.
A mallet for driving the brass valve into a beer barrel. It is made of beech and was glued several times and is colorless varnished.
With this bow-shaped bung wrench it is easy to close and open the bung screw. The key is made of stainless steel and convinces with its high stability. Two different versions: - Square -sheet pile key made of stainless steel (22.5x22.5...
Bung hole ring - stainless steel for screwing into the bunghole. Made of high-quality stainless steel from V4A, to be screwed into the bunghole of the barrel. The barrel can then be closed pressure-safe by the corresponding counter...